Section 1 A633GrD Executive Standards
1.1This standard applies to normalized high-strength low-alloy structural steel plates for welding, riveting or bolted structures.
1.2This steel plate is particularly suitable for use in a low temperature environment of ≥ -50 ℉ [-45 ℃], because this environment requires that the steel A633GrD performs the notch toughness of the standard plate better than the rolled steel plate with similar strength levels.
Section 2 A633GrD Reference Standard
A6/A6M General Requirements For Hot Rolled Structural Steel Plate, Section Steel, Steel Sheet Pile And Steel Bar
A673/A673M Sampling Method For Impact Test Of Structural Steel
Section3 A633GrD Delivery Status
1.The steel plate should be normalized: Heating the steel plate to a suitable temperature capable of generating austenite structure but not exceeding 1700 ℉ [925 ℃], holding at this temperature for a period of time, allowing the entire steel plate to be uniformly heated and then allowing it to be cooled in air.
2.If the purchaser decides to carry out the required heat treatment, the steel sheet shall be accepted at the factory based on the test of the sample that has been heat treated according to the demand order. If the purchaser's order does not state the heat treatment requirements for the sample, the manufacturer shall heat treat the sample as it sees fit. The manufacturer shall notify the acquirer of the process of heat treatment of the sample at the factory.
- August 30, 2018The methods for classifying pressure vessels in different countries vary from country to country. This section focuses on the classification methods in China's Pressure Vessel Safety Technology Superv...view
- August 6, 2018Why does the thickness of the steel plate have nothing to do with the safety?The structure of the car is like a lanternThe structure of this lantern is very similar to that of our car. It is a skeleto...view
- November 13, 2020In the production of a steel flat bar, a steel flat bar finishing machine is needed. Its working principle is to arrange the two sets of cold steel flat bar blank to be staggered up and down and using...view
- August 6, 20181.Thin steel plate is the steel plate with a thickness of 0.2-4mm produced by hot or cold rolling method. Thick steel plate is the general designation of steel plate with a thickness of more than 4mm....view